Training is not required for the
AutoTEMP system if you are already
proficient using a CAD program.
Installation of the Controller
Software can be done over the phone
in about 30 minutes.
If you cannot use CAD
If
you do not have a user that is proficient
with a CAD program, we have three different
options for getting you trained. Any of the
three methods will result in the CAD
operator being able to do basic drawings
2.
Personal Training (Additional
charge applies). At our location
in
North Carolina – we have a training room setup
exclusively for
training 2 people at a time. The cost for training 2
operators is the
same as the cost for training 1 operator – so take
advantage of
having a backup operator. Typically training takes 2
days.
3.
Personal ON-SITE Training
(Additional Charge applies).
When
available – we have the ability to come to your site
and train your
operators. Again, we limit this to 2 users to keep the
training time
reduced. Training time is 2 days
If you have any questions on any of our services, call us
Toll Free at 800.759.6268, email
us, or use our
Online Request
Form to tell us how we can assist you.
